Cisco 6800 Series Administration Manual page 136

Add or Edit Repeaters Web Page Fields
Field
FWU Progress
Add or Edit Repeaters Web Page Fields
These are the fields displayed on the Repeater web page of the base station. This page displays when you
add or change the configuration of a repeater.
Table 57: Repeater Web Page Fields
Field
Name
DECT Sync mode
Cisco IP DECT 6800 Series Administration Guide
128
Contents Description
This field is read-only Identifies the firmware update (FWU) state:
Contents Description
String Identifies the repeater name. You might want to set
the name to a location
Choice: Indicated the registration type for the repeater.
• Manual
• Local Automatic
• Off—Identifies that the sw version field is set to
0 in the Firmware Update page.
• Initializing—Identifies that the update process
is starting.
• X%—Identifies the progress of the update, where
X is the amount of progress (0–100)
• Verifying X%—Identifies that the firmware
verification is in progress before it is used.
• Conn.term.wait—Identifies that the repeater
firmware update is complete and the repeater
reset is in progress.
• Complete—Identifies that the firmware update
is complete.
• Error—Identifies that the update was not
successful. Possible reasons included:
• File can't be found.
• File isn't valid.
• Manual: You need to manually assign
parameters.
• Local Automatic: The repeater detects the base
signal and automatically configures.
Monitoring