Cisco 6800 Series Administration Manual page 101

Monitoring
Field
Outbound Proxy
Enable Conference Server
Conference Server
Call Log Server
Reregistration time (s)
Registration Retry Interval
Registration Retry Interval Long
Registration Retry RSC
Contents
IP address, DNS address or
URL
Values:
• Disabled (default)
• Enabled
IP address
IP address
Integer
Range: 1–65636
Default: 3600
Integer
Range: 1–2147483
Default: 30
Integer
Range: 1–2147483
Default: 1200
Description
Identifies the Session Border Controller or SIP server outbound
proxy.
Set the outbound proxy to the address and port of the private NAT
gateway, so that SIP messages are sent through the NAT gateway.
Controls the use of the external conference server.
• Disabled: No external conference server is configured. When
the user starts a conference, the handset starts a conference
with the internal three-party conference feature.
• Enabled: An external conference server is configured. When
the user starts a conference, the handset starts a conference
on the conference server configured in the Conference
Server field.
Identifies the IP address of the service provider's conference
server, if available.
Indicates the XSI Call Log Server.
When set, the handset logs calls on the call log server. If left blank,
the handset uses the local call log.
Indicates the time in seconds for a valid SIP registration and
represents the maximum time between SIP registrations for the
SIP account.
Note We recommend that you don't set this below 60
seconds.
Identifies the time in seconds to wait before the handset retries
registration after a failed registration. This is used when the
registration failure message is Retry Reg RSC.
Identifies the time in seconds to wait before the handset retries
registration after a failed registration. This is used when the
registration failure message is something other than Retry Reg
RSC.
If the field is set to 0, the handset doesn't retry the registration.
This field needs to be a larger interval than the value in
Registration Retry Interval.
Identifies the Response SIP Code (RSC) that triggers a retry.
You can set up to 4 comma-delimited values and use the wildcard
character (?). For example, you could enter 5??,6??.
Cisco IP DECT 6800 Series Administration Guide
Servers Web Page Fields
93