Cisco 6800 Series Administration Manual page 36

Mount the Base Station or Repeater on the Ceiling
Step 5
Base station only: Connect the Ethernet cable to the device and route the cable through the slot in the device.
Step 6 Provide power to the device:
• Base station with PoE on the LAN: Additional power is not required.
• Base station without PoE: Plug the power adapter into the base station and route the cable through the
slot in the base station.
• Repeater: Plug the power adapter into the repeater and route the cable through the slot in the repeater.
Step 7
Align the slots in the bracket with the slots in the device and turn left until the device locks in place.
This graphic shows the alignment of the mounting bracket to the base station. The back of the repeater is
similar to the base station.
Cisco IP DECT 6800 Series Administration Guide
28
Hardware Installation