Cisco 6800 Series Administration Manual page 181

Troubleshooting
Procedure
Step 1
Click Management.
Step 2 In the Syslog/SIP Log section, change the Upload of SIP Log to Enabled.
Step 3
In the Syslog/SIP Log section, change the Syslog Level to the required level.
Step 4 Click Save.
Step 5
After you capture logs, click Management.
Step 6 (Optional) In the Syslog/SIP Log section, change the Upload of SIP Log to Enabled.
Step 7
In the Syslog/SIP Log section, change the Syslog Level to Normal Operation.
Step 8 Click Save.
Turn On Dualcell Debug Logs
To debug dualcell system problems, enable debugging. This causes the log files to contain extra log messages
about dualcell.
Note After you get the required logs, make sure you set the debug level to Disabled.
Procedure
Step 1 Access a base station web page. See
Step 2
Click Dual Cell.
Step 3 Set Dual cell debug to Both.
Step 4
Click Save.
Turn on Multicell Debug Logs
In order to debug multicell problems, you need to turn multicell debugging. This causes the log files to contain
extra log messages about multicell.
Note
After you get the required logs, make sure you return the debug level to Disabled.
Procedure
Step 1
Access a base station web page. See
Step 2 Click Multi Cell.
Sign in to the Administration Web Page, on page
Sign in to the Administration Web Page, on page
Cisco IP DECT 6800 Series Administration Guide
Turn On Dualcell Debug Logs
42.
42.
173