Cisco 6800 Series Administration Manual page 110

Network Web Page Fields
Field
Failover SIP Timer B
Failover SIP Timer F
Failover Reconnect Timer
Local SIP port
SIP ToS/QoS
RTP port
RTP port range
RTP ToS/QoS
Reject anonymous calls
Cisco IP DECT 6800 Series Administration Guide
102
Contents Description
Integer Indicates the time to wait for a response from an
INVITE message from the SIP server before failover
Default: 5
is triggered.
Integer Indicates the time to wait for a response from an
non-INVITE message from the SIP server before
Default: 5
failover is triggered.
Integer Controls the delay, in seconds, between queries from
the base station to locate the primary server during
Default: 60
failover.
This field is new for Firmware Release 4.7.
Integer Indicates the SIP signaling source port.
Range: 0–65535
Default: 5060
Integer Indicates the priority of call control signaling traffic,
based on the IP layer Type of Service (ToS) byte. ToS
Range: 0–65535
is the same as Quality of Serviec (QoS) in
Default: 0x68 packet-based networks.
Integer Indicates the first RTP port to use for RTP audio
streaming.
Range: 0–65535
Default: 16384
Integer Indicates the number of ports to use for RTP audio
streaming.
Range: 0–65535
Default: 40
Integer Indicates the priority of RTP traffic, based on the IP
layer ToS byte. For more information. see RFC 1349.
Range: 0–65535
Default: 0xB8
Note
Values: Indicates if the call should be rejected if it is made
anonymously.
• Disabled (default)
• Enabled
• Bits 7–5 define precedence
• Bits 4–2 define ToS
• Bits 1–0 are ignored.
The cost bit is not supported.
Monitoring