Configuring Sbus Modules; 1: Assigning Sbus Module Ids - Honeywell Farenhyt Series Installation And Operation Manual

The 5865 ships with a set of zone description labels that can be inserted into the 5865 board assembly. These labels can be used in a type-
writer or can be written on by hand. Slide the labels under the plexiglass as shown in Figure 4.40. The LEDs will show through the label
when illuminated.

4.13 Configuring SBUS Modules

This section describes how to configure any system hardware modules that have been added to the system.
4.13.1 Assigning SBUS Module IDs
When installing a hardware module (see Table 4.1 for compatible devices), you must use the DIP switches on the module to assign an
ID# to the module. Address zero is an invalid address and is not allowed.
IFP-300 / IFP-300ECS Manual P/N LS10145-001SK-E:B 12/18/2017
Figure 4.40 Inserting Zone Description Labels
48