Honeywell Farenhyt Series Installation And Operation Manual page 146

Operation
Occurs When
Mode
Supervisory
The system
detects a
supervisory
condition.
A Supervisory
with a CO
detector.
A system trouble
condition occurs.
Trouble
A single detector
trips in a 2-Count
zone. (2-Count
means two
detectors must
Prealarm
trip before an
alarm is
reported.)
Reset The RESET
button is pressed
followed by a
valid code, if
necessary.
IFP-300 / IFP-300ECS Manual P/N LS10145-001SK-E:B 12/18/2017
System Behavior
The system will report events to the central
station.
The on-board annunciator sounds a loud,
pulsing beep to distinguish supervisory
signals. For Fire Supervisory the sequence is
two seconds on, two seconds off. For ECS
Supervisory, the sequence is two seconds on,
three seconds off.
SUPERVISORY LED is on.
The LCD displays a screen similar to this one.
The system will report events to the central
station.
The on-board annunciator sounds a loud,
pulsing beep in the sequence ¾ of second on,
eight seconds off.
SYSTEM TROUBLE LED is on.
The LCD displays a screen similar to this one.
Touchpad PZT beeps.
The LCD displays a screen similar to this one.
All LEDs are on briefly then the LCD displays
"RESET IN PROGRESS". If the reset process
completes normally, the date and time normal
mode screen displays.
Table 10.2 Operations Mode Behavior
In This Mode You Can
Press down arrow to view the fire supervisory
condition. A screen similar to this one displays.
Press SILENCE to silence the annunciator.
Press down arrow to view the fire trouble. A
screen similar to this one displays.
Press SILENCE to silence the annunciator.
Once the trouble condition has been fixed, the
system will restore itself automatically.
Press down arrow to view the Prealarm. A screen
similar to this one.
All system operations are available in this mode.
Menus are not available during the reset process.
142