Honeywell Farenhyt Series Installation And Operation Manual page 205

These instructions must be framed and displayed next to the IFP-300ECS panel in accordance with
NFPA 72 fire code for Local Protected Fire Alarm Systems.
Operation
Silence Alarms and Press SILENCE then enter a code if prompted. Silence LED will light.
Troubles
1.
2.
Reset Alarms
3.
Note: To reset ECS at an LOC, the user must gain ECS Control (See Figure 1).
The highest priority event will display first. Press the Down arrow to view location and type of alarm or trouble.
View all active
alarms, troubles,
and supervisory
signals
1. Press ENTER to access Main Menu.
2. Press 2 to select Point Functions.
View a Point's
3. Then press 2 to select Point Status.
Status
4. Select the module the device is located on by using the Up or Down button. Then press ENTER.
5. Enter the point number.
Hold the DRILL button and then enter a code if prompted. OR
1.
Conduct a Fire Drill
2.
3.
4.
1.
2.
Set Time and Date 3.
4.
5.
1.
2.
3.
Enable / Disable a 4.
Point
5.
6.
7.
To Gain / Request
ECS Control
1.
Note: When ECS Control LED is blinking, another LOC has ECS Control. ECS Control LED is on steady when the
For Service call:
P/N LS10163-001SK-E Rev A
Basic Operating Instructions
FS = Fire System ECS = Emergency Communication System
Press RESET.
Press 1 to Reset Fire System.
Press 2 to Reset Emergency Communication. System.
Enter the installer code. The panel will automatically go to the main menu.
Press 1 to select System Tests.
Enter code if prompted, then press 1 to select Fire Drill.
Press ENTER to start the fire drill, and Press ENTER to end the fire drill.
Press ENTER to access Main Menu.
Then press 4 to select Set Time & Date. Enter a code if prompted
Make changes in the fields on the screen as necessary.
Press ENTER if you wish to keep the changes.
Press ENTER to set the entered time and date.
Rotate the key or enter a code to access to access Main Menu.
Press 2 to select Point Functions.
Press 1 for Disable / Enable Pt
Press 7 for Disable / Enable Pt.
Use the Up or Down button to move through the list. Then press ENTER to select the module where
the point you want to disable/enable is located
Enter the point or circuit number that you want to disable/enable.
Press the right arrow key to toggle between NORMAL (enable) or DISABLE.
Press the
LOC has ECS Control.
Model IFP-300ECS
Task to Perform
Button and follow the on-screen Instructions.
ECN: 16-0218