Change Device Configuration - Modules - Honeywell XLS80e Manual

XLS80e Fire Alarm Control Panels
SELECTION
TO
MAKE
5.1.4 Change Device Configuration -
Modules
The following can be altered for modules:
a. The device type.
b. The zone or cell in which the device is
placed.
c. The device location text. Note that the zone
text is displayed but cannot be edited here
(it is edited in the Zone Text Editor, see
Section 6.3).
d. Module supervision
Section 13 for recommendations).
e. Verification delay times. See Section 13 for
recommendations.
f. Priority options.
g. Silence and Pulse options.
5.1.4.1 Edit Device Type
Select the required TYPE. If no module exists
at the entered number, its type is NONE.
Available types are:
Type Description
NONE Deleted - no module
exists at this address
MCP Manual Call Point
BELL Bell/sounder circuit or
loop-powered sounder
CTRL (generalised)
Control Function
MON (generalised)
MONitoring function
SPRK Sprinkler Monitor
ASPR Aspirator Interface
AUX. Auxiliary Module
ZMX Low cost version of CDI
CDI Conventional
Detector Interface
LBM Loop Booster Module
Note: While sensor types are Physical device
types (they are determined by the
sensor hardware and must be selected
so as to match the actual sensor
installed at that address), module types
are Logical device types. These refer
to one of the physical module types as
shown in the table above.
39
options (see
Physical Type
MMX
CMX
CMX
MMX
-
-
ZMX
CDI
LBM
Honeywell, Issue 9
March 2007