Honeywell Farenhyt Series Installation And Operation Manual page 145

Operation
Occurs When
Mode
No alarm or
trouble condition
Normal exists and
menus are not in
use.
A smoke
detector goes
Alarm
into alarm or a
pull station is
activated.
141
panel#
site
Figure 10.5 Event Display after Two Minutes Sitting idle
SYSTEM POWER LED is on.
The All Systems Normal display indicates that
the system is in normal mode.
The current date and time display on the last
line of the LCD.
The system will report events to the central
station.
The on-board annunciator will sound loud,
steady beeps to distinguish Alarm signals. For
Fire Alarm, the sequence is a loud steady
beep.(Any notification devices attached to the
system will also sound). For ECS Alarm, the
sequence is four seconds on, one second off.
GENERAL ALARM LED is on.
The LCD displays a screen similar to this one.
Table 10.2 Operations Mode Behavior
module#
System Behavior
IFP-300 / IFP-300ECS Manual P/N LS10145-001SK-E:B 12/18/2017
In This Mode You Can
Enter the appropriate code to activate the User or
Installer Menu.
Press the down arrow to view the alarm. A screen
similar to this one displays.
Press SILENCE to silence the annunciator (and
any notification devices attached to the system).
When the alarm condition clears, press RESET to
restore the panel to normal.