Flush Mounting; 2: Connecting The Ra-1000 To The Panel - Honeywell Farenhyt Series Installation And Operation Manual

The RA-1000 comes from the factory fully assembled. You must disassemble it for mounting. To disassemble the annunciator, use a 5/64
hex wrench to remove the set screws, located on the bottom of the annunciator bezel. (See Figure 4.18 for location of the set screws.)

Flush Mounting

This section of the manual describes flush mounting. You can flush-mount with or without an electrical box.
4.6.2 Connecting the RA-1000 to the Panel
Connect the RA-1000 to the panel as shown in Figure 4.19.
IFP-300 / IFP-300ECS Manual P/N LS10145-001SK-E:B 12/18/2017
Figure 4.18 Annunciator Back Box and Bezel Details
Figure 4.19 Model RA-1000 Connection to the Panel
Supervised
Power Limited Class B
36