Draytek Vigor2862 Series User Manual page 974

S y n t a x
S y n t a x
ha show –c
ha show –g
S y n t a x
S y n t a x
Parameter
-c
-g
E x a m p l
E x a m p
> ha show -g
% High Availability
% Redundancy Method
% Group ID
% Priority ID
% Preempt Mode
% Update DDNS
% Management Interface : LAN1
% Authentication Key
% Syslog
%
% [ Index | Enable | Virtual IP ]
% LAN1
% LAN2
% LAN3
% LAN4
% LAN5
% LAN6
% DMZ
% [ Index | Enable | Virtual IPv6 ]
% LAN1
% LAN2
% LAN3
% LAN4
% LAN5
% LAN6
% DMZ
>
T e l n e t C o m m
T e l n e t C o m m
This command is used to display HA status information.
S y n t a x
S y n t a x
ha status –a [Detail Level]
ha status –m [Detail Level]
S y n t a x
S y n t a x
Parameter
-a
-m
Detail Level
E x a m p l
E x a m p
> ha status -m 2
% [Local Router] DrayTek
% IP
% Status
958
D e s c r i p t i o n
D e s c r i p t i o n
Description
Show the settings of config sync.
Show the settings of general setup.
e
l e
: Disable
: Active-Standby
: 1
: 10
: Enable
: Disable
: draytek
: OFF
On 192.168.1.0
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
a n d : h a s t a t u s
a n d : h a s t a t u s
D e s c r i p t i o n
D e s c r i p t i o n
Description
Show the status for all of the routers in HA group.
Show the status of local router only.
0: Important status.
1: Important status, plus some information.
2: Show settings
e
l e
: 192.168.1.1 (FE80::21D:AAFF:FEC6:4C50)
: !
Vigor2862 Series User's Guide