Draytek Vigor2862 Series User Manual page 973

-v <1-255>
-R
-p <1-30>
-k <key>
-u <1/0>
-m <interface>
-s
-y
-c <1/0>
-I -[M|H|D] <interval>
-h -<4/6><Subnet> [<Virtual
IP>]
-d -<4/6><Subnet>
-o <1/0>
E x a m p l
E x a m p
> > ha set -h -4 LAN1 192.168.1.1
% Enable IPv4 Virtual IP on LAN1
% Virtual IP can not be same as router IP (192.168.1.1)!!!
>
T e l n e t C o m m
T e l n e t C o m m
This command can be used to show the settings information about config sync and general
setup.
Vigor2862 Series User's Guide
1: Active-Standby
0: Hot-Standby
Specify the group ID (VHID)
1- 255: Setting range.
Set HA settings to Factory Default.
Specify the Priority ID.
1-30: Setting range.
Specify the Authentication Key.
Key: Max. 31 Characters.
Enable or disable the function of Update DDNS.
1: Enable. When a router changes HA status to primary, it will
update DDNS automatically.
0: Disable.
Specify the management interface.
Interface: LAN1 ~ LAN6, DMZ.
It means to get the newest status of other router (except the local
router).
It means sync local config to other router. Primary can executes this
command. Secondary can not execute this commad.
Enable or disable the function of Config Sync.
1: Enable.
0: Disable.
Set the Config Sync Interval for HA. Minimum interval is 15 minutes.
-M: Minute. Setting range is 0/15/30/45. (e.g., ha set -I -M 30)
-H: Hour. Setting range is from 0 to 23. (e.g., ha set -I -H 12)
-D: Day. Setting range is from 0 to 30. (e.g., ha set -I -D 15)
Enable and set virtual IP to the subnet.
4: IPv4; 6: IPv6.
Subnet: LAN1 to LAN6, DMZ.
Virtual IP: The type format shall be "xxx.xxx.xxx.xxx". (e.g,
192.168.1.0)
For example, to enable a virtual IP to the sunet, simply type:
ha set –h LAN1 192.168.1.5
Disable a virtual IP to the subnet.
4: IPv4; 6: IPv6.
Subnet: LAN1 to LAN6, DMZ.
For example, to disable a virtual IP to the subnet, just type:
ha set –h LAN1
Run DARP protocol on IPv4 or IPv6.
0: IPv4
1: IPv6
e
l e
a n d : h a s h o w
a n d : h a s h o w
957