Draytek Vigor2862 Series User Manual page 142

ATM OoS
Bridge mode
After finished the above settings, click OK to save the settings.
A A d d v v a a n n c c e e
Such configuration is applied to upstream packets. Such information will be provided by ISP.
Please contact with your ISP for detailed information.
126
Encapsulation - (Available when WAN Type is ADSL)
Encapsulation mode used for the ASDL connection. Contact
your ISP or carrier for the appropriate setting.


Add VLAN Header – (Available when WAN type is ADSL) If
selected, enable VLAN tagging on this PVC.


Configures the Quality of Service (QoS) of the ATM circuit.
QoS Type - Select a proper QoS type for the channel.
Type the values for PCR (Peak Cell Rate), SCR (Sustainable
Cell Rate) and MBS (Maximum Burt Size) respectively.
If selected, bridge this channel to one or more LAN ports.
Physical Members– Group the physical ports by checking the
corresponding check box(es) for applying the bridge
connection.
Note: LAN port P1 is reserved for NAT use and cannot be
selected for bridging.
d d
VC MUX: Virtual Circuit Multiplexing.
LLC/SNAP: Logical Link Control/Subnetwork Access
Protocol.
VLAN Tag – Type the value as the VLAN ID number.
Valid settings are in the range from 1 to 4095. The
network traffic flowing on each channel will be
identified by the system via their VLAN Tags. Channels
using the same WAN type may not configure the same
VLAN tag value.
Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
Vigor2862 Series User's Guide