Draytek Vigor2862 Series User Manual page 498

ACS Server
CPE Client
Periodic Inform Settings
STUN Settings
Apply Settings to APs
482
URL – Such data must be typed according to the ACS (Auto
Configuration Server) you want to link.
Wizard – Click it to enter the IP address of VigorACS

server, port number and the handler.
Acquire URL form DHCP option 43 – Check the box to

get the URL from DHCP option 43.
Username/Password – Such data must be typed according to
the ACS (Auto Configuration Server) you want to link.
Test With Inform – Click it to send a message based on

the event code selection to test if such CPE is able to
communicate with VigorACS SI server.
 Event Code – Use the drop down menu to specify an
event to perform the test.
Last Inform Response Time – Display the time that VigorACS
server made a response while receiving Inform message from
CPE last time.
Such information is useful for Auto Configuration Server.
Port – Sometimes, port conflict might be occurred. To solve
such problem, you might change port number for CPE.
Username and Password – Type the username and password
that VigorACS can use to access into such CPE.
Enable – It is the default setting.
Time Interval - Please set interval time or schedule

time for the router to send notification to CPE.
Disable - Click it to close the mechanism of notification.
Disable - The default is Disable.
Enable - Please type the relational settings listed below:
Server Address – Type the IP address of the STUN

server.
Server Port – Type the port number of the STUN server.

 Minimum Keep Alive Period – If STUN is enabled, the
CPE must send binding request to the server for the
purpose of maintaining the binding in the Gateway.
Please type a number as the minimum period. The
default setting is "60 seconds".
Maximum Keep Alive Period – If STUN is enabled, the

CPE must send binding request to the server for the
purpose of maintaining the binding in the Gateway.
Please type a number as the maximum period. A value
of "-1" indicates that no maximum period is specified.
This feature is able to apply TR-069 settings (including STUN
and ACS server settings) to all of APs managed by Vigor2862
at the same time.
Disable – Related settings will not be applied to VigorAP.
Enable – Above STUN settings will be applied to VigorAP after
clicking OK. If such feature is enabled, you have to type the
password for accessing VigorAP.
AP Password – Type the password of the VigorAP that

you want to apply Vigor2862's TR-069 settings.
Specify STUN Settings to APs – If you want to apply specific
STUN settings (not the STUN Settings configured for
Vigor2862) to VigorAPs to meet specific requirements, simply
check this box. Then, enter the server IP address, server
Vigor2862 Series User's Guide