Draytek Vigor2862 Series User Manual page 852

Parameter
[<command>
<parameter>|...]
-t <sec>
-u <sec>
-i <sec>
-w <sec>
-s <sec>
-f
-l <List>
E x a m p l
E x a m p
> portmaptime -t 86400 -u 300 -i 10
> portmaptime -l
------ Current setting ------
TCP Timeout
UDP Timeout
IGMP Timeout : 10 sec.
TCP WWW Timeout: 60 sec.
TCP SYN Timeout: 60 sec.
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure PPA mode.
ppa [-<command> <parameter> | ... ]
ppa n [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
[<command>
<parameter>|...]
-m <mode>
-p <proto>
-b 1/0
-M enable/disable
-S
836
e
l e
: 86400 sec.
: 300 sec.
a n d : p p a
a n d : p p a
D e s c r i p t i o n
D e s c r i p t i o n
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
It means "TCP" protocol.
<sec>: Type a number to set the TCP session timeout.
It means "UDP" protocol.
<sec>: Type a number to set the UDP session timeout.
It means "IGMP" protocol.
<sec>: Type a number to set the IGMP session timeout.
It means "TCP WWW" protocol.
<sec>: Type a number to set the TCP WWW session timeout.
It means "TCP SYN" protocol.
<sec>: Type a number to set the TCP SYN session timeout.
It means to flush all portmaps (useful for diagnostics).
List all settings.
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Specify a mode.
1=auto
2=manual(traffic)
3=manual(qos)
4=manual(specific hosts)
0=disable
Specify a protocol.
proto - 1-TCP; 2-UDP; 3-Both.
Enable/disable TWO-way hardware acceleration.
Enable/disable the multicast hardware acceleration.
Show multicast table in HW accleration
Vigor2862 Series User's Guide