Honeywell Vibrex 2000 User Manual page 54

Chapter 3 – Getting Started
Setting DIP Switches -
can be set by the DIP switches (DIP SW). Set the printer's DIP
switches, as follows:
1. Slide the power switch to OFF.
2. Slide the power switch to ON while pressing the
button. Release the
settings starts printing out.
3. The printout of the current settings is followed by the
prompt:
Continue?
Write?


4. Dip SW1 is printed, prompting the input of new settings
for switch No. 1 through 8 of DIP SW-1.
NOTE: Always input either ON or OFF for every setting in
order for switch No. 1 through 8 because the DIP SW set
mode cannot be canceled once it is initiated.
• ON can be set by pushing the
• The setting is printed out after the
5. As soon as switch No. 8 is set, the printer once again
prompts with Continue? or Write?, and stops. Repeat
step 3 for DIP SW-2 and -3.
NOTE: The on-line lamp lights when the
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
To change the DIP SW settings, push the
button, and go
to step 4.
To leave the DIP SW settings unchanged, push the
button, and go to step 6.
FEED
once and OFF by pushing the
once.
button is pushed to confirm the new
FEED
setting.
The start-up settings and input method
button after a list of the current
ONLINE
: Push 'On-line SW'
: Push 'Paper feed SW'
ONLINE
FEED
13841 Rev A
38
ONLINE
ONLINE
button
button
or
ONLINE
button is
ONLINE