Job Selection - Honeywell Vibrex 2000 User Manual

paragraph 5.6.5, "Removing and Editing Models and
Charts").
5.6.4
The balancing steps can be grouped together into a series of runs
called jobs. (They are also called sessions on the printouts.)
During the course of the balance session you may want to turn
off the unit to conserve battery power (or it may power off itself
with 10 minute auto-power-off option). When the unit is
powered back on, a
you are in the middle of a job and the
main menu key is pressed. This allows you to continue a current
job or start a new one. Note that up to four jobs can be worked
simultaneously. For example, both a main and tail rotor can
worked on the ground at the same time.

Note: The job selection screen for the EV2K+ series works
differently than it does for the V2K and V2K+
series.Normally, you would just press
the job you were on when you powered off. Otherwise, press
the
START
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.

Job Selection

JOB SELECTION
? J O B S E L E C T I O N
A - 1 0 9 E P o w e r
► S T A R T N E W J O B
J o b 1 1 5 N O V 1 4 1 0 : 0 0
► C O M P : < M R S i d e T r k r >
R u n
► < C O N T I N U E J O B >
t o d o , p u s h S T A R T
key to select a different component, then press
COMP:
.
Chapter 5 – General Operation
menu will be displayed if
HELICOPTER BALANCE
1 [ A N N O T A T E ]
13841 Rev A
179
to continue on
START