Honeywell Vibrex 2000 User Manual page 13

After First Time Startup, Balance Run No. 1

Make sure the proper model is selected at the Choose A/C
Model screen, then press

Select the Component, Flight Regime and Change Type to
be used for balance, then press

Select Measurement Sensor. The default EV2K+ balance
channel can be changed, if desired. AutoCorrection
may also be toggled to <ON >. Press

Operate the component at the desired balance RPM. When
the RPM is steady, press

When the Vibrex unit has finished collecting data, press
START

Press

Apply changes exactly as specified or use
SOLUTION

Press
otherwise ensure the proper solution (change) type is
selected and press

Implement the solution and power off the Vibrex unit.
After Balance Run No. 1

Turn on the Vibrex unit.

Select Helicopter Balance (or Fixed Wing
Balance) from the Main Menu screen.

Select the component and <Continue Job> then press
START.

Operate the helicopter/aircraft at the same RPM as done in
Run No. 1. When the RPM is steady, press

When the Vibrex unit has finished collecting data, press
START

Continue making adjustments until the component yields the
desired IPS level, then press
Balance Quality screen.
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
.
START to view the solution.
to view other solution options.
Done (Next Run/Job)
START
.
13841 Rev A
START.
START.
START.
.
START
ALTERNATE
if balance is acceptable,
.
START
from the Aircraft
DONE
xiii
Quick Reference Guide
.