Honeywell Vibrex 2000 User Manual page 187

8. The BAL MEAS QUALITY screen shows the quality of
balance measurement (similar to propeller balance described
in paragraph 5.4.2.2, "Balance Quality Indicator"). It also
provides a junction point for getting an adjustment solution
or continuing on to the next run or job.


Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
B A L M E A S Q U A L I T Y
B E T T E R [ = = = = X = ] W O R S E
0 . 2 8  U n a c c e p t ab l e
► D O N E ( N E X T R U N / J O B )
► < P i t c h L i n k > S O L T N
t o s o l v e , p u s h S T A R T
Press the
DONE (NEXT RUN/JOB)
next run or job. Note that runs with different regimes
and/or change types can be "stacked" up within the same
job. For example, when acceptable ground balance has
been obtained, the current balance job can be continued
with the hover regime. This is useful to keep balance
sessions together when printing or reviewing the
solutions. (The terms "session" and "job" are used
interchangeably within the context of the EV2K+.)
Press the
<change type> SOLTN
compute different types of solutions. This key has no
effect if there is only one change type for this
measurement. The change type was already selected
before the measurement acquisition, but this key allows
the user to change his or her mind or to experiment with
different types of solutions without having to retake the
measurement.
Chapter 5 – General Operation
context key to
13841 Rev A
171
context key to the