Table of Contents
Advertisement
4. This screen allows you to edit the settings for the balance
component. This may be useful if a particular adjustment
point already has an adjustment applied, for example weight
already added or tab already bent. By default, the solution
algorithm will respect the manufacturer's limits and not give
solutions over these limits.
5. Note: Generally the default settings can be used in most
cases. when implementing a solution, if a limit is exceeded,
the current settings can be edited and a new solution
calculated that respects these limits. This can be done
using
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
A - 1 0 9 E P o w e r
► B O O K K E E P I N G : < O F F >
► E D I T S E T T I N G S
f o r M R S i d e T r k r
► R E S E T A L L S E T T I N G S
i f o k , p u s h S T A R T
ALTERNATE SOLUTION
BOOKKEEPING <OFF/ON>
are accumulated at the end of a run when you choose
NEXT RUN (MADE).
suggested solutions will not exceed manufacturer's
limits unless this option is overridden in the
ALTERNATE SOLUTIONS
functions as if you pressed
time this menu is entered.
Press
EDIT SETTINGS
Note: A warning screen will warn if a value is entered
that exceeds manufacturer's limits. This is only a
warning – the edited value will still be accepted.
Chapter 5 – General Operation
R u n 1
as described below.
controls whether changes
If bookkeeping is ON, the
menu. Bookkeeping OFF
RESET ALL SETTINGS
to edit the settings.
13841 Rev A
167
each
Advertisement
Chapters
Table of Contents
