Table of Contents
Advertisement
Chapter 5 – General Operation
These conditions minimize spurious or unreasonable correction
values. "Auto-correct once" means that, until these conditions
are met, no correction is done. Once they are met, auto-
correction is done once and applied through-out the remaining
runs.
Auto-corrected from
The
finish a run or a job and auto-correction factors have been
computed that are different from the default factors:
The screen shows the internal chart coefficients before and after
correction has taken place. The "u/IPS" represent change type
units/IPS for whatever the current change type is.
Press the
the new correction values. You will be prompted for a new
helicopter name.
CAUTION: The
pressed at this point to automatically save these parameters
without having to manually enter them later (see
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
b. The sensitivity of the correction factor is over 25%,
c. The correction magnitude is not more than 4 times
the expected moveline length.
A - 1 0 9 E P o w e r
A u t o - c o r r e c t e d f r o m
2 4 . 0 0 u / I P S @ 0 1 : 0 0
1 9 . 5 0 u / I P S @ 0 1 : 4 6
► S A V E C O R R E C T E D C H A R T
D o n ' t s a v e , p u s h S T A R T
SAVE CORRECTED CHART
SAVE CORRECTED CHART
screen is reached whenever you
R u n 3
t o
13841 Rev A
178
context key to save
key must be
Advertisement
Chapters
Table of Contents
