Table of Contents
Advertisement
Choosing this option will open a set of menus that allow you
to exclude and/or edit individual adjustment points. If any
adjustment points are excluded in the lower menus, the key
will change to
selected adjustment points are used in the solution. This list
can be seen by pressing the
excluded points then the
<NONE>
Pressing
allows you to select the change type. In most cases there will
only be one change type available but for "non-orthogonal"
solutions (solutions that unequal correction angles or
sensitivities, i.e. many tail rotors) there may be two, e.g.
Span Weight and Chord Weight. Select change type and then
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
ADJ PTS: [INCL ALL]
EXCLUDE
and the
Excluded Adj Points
?
S E L E C T A D J P O I N T S
E X C L U D E : < N O N E >
►
E x c l u d e d A d j P o i n t s :
E D I T A D J P O I N T S
►
i f o k , p u s h S T A R T
EDIT ADJ POINTS
?
E D I T A D J P T S E T T I N G
▲ P R E V
A d j p t
< I N C L > [ + ] [
►
▼ N E X T
w h e n d o n e , p u s h S T A R T
13841 Rev A
Chapter 5 – General Operation
indicating that only
key. If there are no
ADJ PTS
key will be set to
list will be empty.
will transition to a screen that
S e t t i n g
0 . 0 0 ]
g r a m s
175
Advertisement
Chapters
Table of Contents
