Installing The Module In The Chassis; To Install The Receiver Modules In The Host Module - Cisco Prisma II Installation Manual

Chapter 2 Module Installation

Installing the Module in the Chassis

To Install the Receiver Modules in the Host Module

Note:
All Prisma II high-density application modules must be installed in a host

module before they can be mounted in a standard Prisma II Chassis.
Prisma II host modules prior to Rev C (date codes through A2006) do not

support the Controller Area Network (CAN) bus.
To support CAN bus redundancy, the ICIM2 must be Rev B or later.

56