Model 6820 / 6820-EVS Installation Manual
2.
Remove knockout holes as needed for wires. See Figure 4-24 for backbox knockout locations.
Wire Knockouts
3.
Wire the annunciator board to the main control panel. As described in Section 4.7.2.
4.
Attach the annunciator and door assembly to back box as shown in Figure 4-25 using the supplied screws.
Figure 4-25 Attaching Annunciator / Door Assembly to Backbox
4.7.1.2 Surface Mounting
The Model RA-100TR red trim ring kit is available for use when surface mounting the 6860.
1.
Remove the desired knock out.
Wire Knockouts
Figure 4-24 Back Box Knockout Locations
4-19
LS10144-001SK-E
Wire Knockouts