Honeywell 6820EVS Installation And Optimization Manual page 44

LS10144-001SK-E
the following pages.
The 5860 comes from the factory fully assembled. You must disassemble it for mounting. To disassemble the
annunciator, use a 5/64 hex wrench to remove the set screws, located on the bottom of the annunciator bezel.
(See Figure 4-12 for location of the set screws).
Set screw location.
Loosen set screws to remove bezel
when disassembling annunciator.
Figure 4-11 Annunciator Parts
Holes for surface mounting.
Stand-off
(throughout)
Holes for inserting
wires for flush mounting
(located in all corners).
Figure 4-12 Annunciator Back Box and Bezel Details
Knockout holes
Screw for placement
of mounting wires
(top and bottom).
4-10
Control Panel Installation