Loc Programming; Adding An Loc; Editing An Loc - Honeywell 6820EVS Installation And Optimization Manual

LS10144-001SK-E
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Program Menu.
3. Press 1 to enter Module menu.
4. Press 1 to edit a module.
5. Use the up or down arrow to select the module you wish to edit.
6. Press the right arrow

11.6 LOC Programming

Device Priority is a programmable option for each of the EVS devices:
• EVS-VCM
• EVS-RVM
Each device is assigned a Priority level: Low, Normal, or High.
11.6.1

Adding an LOC

To add new LOCs to the system, follow these steps:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Program Menu.
3. Press 1 to enter Module menu.
4. Press 2 to add a module.
5. From the next screen, add either an *EVS-VCM or **EVS-RVM.
Note: * Only 1 EVS-VCM may be installed per site.
Note: ** Up to 4 EVS-RVMs may be installed per site.
The screen will display "Adding module [#]..." for a few moments. You will be returned to the <New Mod-
ule Type> screen where you can select a name for the module if desired.
6. Add a compatible LCD Annunciator, if desired, to associate with each EVS-VCM or EVS-RVM
You must save changes when you exit the Program Menu or the new module(s) will not be added. For more
information see section 9.2.2.
Note: If you Add a Module that has not been physically connected, the panel will go into trouble after it re-
initializes (when you exit the Program Menu). When the new module is attached, the trouble will restore
automatically the next time you power up the system.
11.6.2

Editing an LOC

When editing EVS LOCs, the features that may be edited are: module ID, module name, number of switch
expanders installed, extended features, microphone type, microphone gain, auxiliary gain, tone gain, message
gain, keypad priority, and associated keypad
To edit an existing module:
1. Enter the installer code.
2. Select 7 for Program Menu.
3. Press 1 to enter module menu.
4. Press 1 to edit a module.
5. Use the up or down arrow to select the module you wish to edit.
ENTER to move to the next selection.
or
11-8
Emergency Voice System Operation