Recording Messages 1-15 Using The Microphone - Honeywell 6820EVS Installation And Optimization Manual

Model 6820 / 6820-EVS Installation Manual
9. When the audio file from the PC is finished playing, press EVS Message Key 3 again to stop the recording.
The Select Key green LED will come on.
10. To playback the recorded message, press the Select Key 1-15 that was just recorded to.
Recording with Aux Audio Input Example:
The user wants to record into memory slot 2 via the Aux Audio Input channel.
Upon entering the Local Recording mode via the keypad menu, the VCM will light the Select Key green LEDs
1-15 for each occupied message slot.
If a message already exists in message slot 2, it must first be erased. Press EVS Message Key 8, then press Select
Key 2, (see Section 11.8.3). When the message has been erased Select Key 2's green LED will turn off.
To record a message, press EVS Message Key 1, then press Select Key 2 (this will use message slot 2 for the
recording). Select Key 2's red LED will begin flashing.
Press EVS Message Key 3 while simultaneously pressing play on the PC to start recording the Aux Audio Input.
When the PC message is done, press EVS Message Key 3 to stop recording. Select Key 2's red LED will stay on
until processing is completed. Select Key 2's green LED comes on after the recording is completed.
Pressing Select Key 2 will start a playback of the recorded message.
Press
Select Key 2
to record
Message to
this slot
11.8.2

Recording Messages 1-15 Using the Microphone

Messages can be recorded into the EVS system by using the on board microphone.
Follow these steps to use the microphone to record your message:
1. Enter programming mode at main control panel.
2. Select option 8 Voice Options.
3. Select 1 for VCM Maintenance.
4. Select option 2 Local Recording.
Note: The VCM will light the green Select Key LED for message slots that are occupied. If a message is already
Figure 11-6 Aux Audio Input Example
11-13
LS10144-001SK-E
Press EVS
Message Key
1 to enter message
slot selection mode
Press EVS
Message Key 3
to start and stop
recording from
the Aux Audio
Input