Zone Accessory Options; View Zone Points; Group; Edit Group - Honeywell 6820EVS Installation And Optimization Manual

LS10144-001SK-E
4. Use the up or down arrow key to scroll through the range or enter directly from the number keys on the
annunciator, then press ENTER.

9.3.1.3 Zone Accessory Options

1. Do steps 1 through 5 of Section 9.3.1.
2. Press 3 to edit the Zone's Accessory options.
Single or Multi-Station cadence pattern (choose from Patterns 00 to 02, 23 if using SK. Choose from 00-16, 23 if
using SD devices). See Appendix D.
CO Single and Multistation Cadence (choose from Cadence Patterns 00 to 02, 23 for SK devices).
Note: The B200S Sounder base provides the recommended CO cadence pattern.
Local Zone (choose Y or N, for Yes or No).
Note: If the SLC protocol is changed from SD to SK series and the cadence is no longer valid for SK, the zone
cadence will be set to constant on.
9.3.2

View Zone Points

To view the points in a zone, follow these steps:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Press 2 to enter zone menu.
4. Press 2 to view zone points.
5. Enter the number of the zone you wish to view, then press ENTER.
9.4

Group

An output group is made up of output points that have been programmed to respond in the same way. Output
groups simplify programming because you only have to program the output characteristics that are common to
all of the group points once, instead of programming each individual point. Once you have defined the
characteristics of output groups, you can assign each point to the appropriate group. All valid output points are
assigned to only one output group. Unused points are not assigned to any output group. Up to 999 output groups
can be defined.
9.4.1

Edit Group

In the edit group option you can program the name of an output group (Section 9.4.1.1) and change the properties
(Section 9.4.1.2) of that group.
To edit a group, follow these steps:
1. Enter the installer code. The panel will automatically go the main menu.
2. Select 7 for Program Menu.
Zone Number
Figure 9-3 View Zone Points Screen
9-6
Zone Name
Programming