Programmable Relays; Remote Station Applications; Keltron Model 3158 Installation; City Box Connection Using The 5220 Module - Honeywell 6820EVS Installation And Optimization Manual

Model 6820 / 6820-EVS Installation Manual
4.17.2

Programmable Relays

The control panel has two Form C programmable relays built into terminals labeled RELAY and RELAY 2. Each
relay provides a normally open and a normally closed contact.
To install one or two programmable relays, follow these steps.
1. Wire Relay 1 and/or Relay 2 as needed for your application. See Figure 4-53 for the location of the relay ter-
minals.
2. Configure the relay through programming (see Section 9.5).

4.18 Remote Station Applications

4.18.1

Keltron Model 3158 Installation

The control panel is compatible with Keltron Model 3158, used for direct connection to a Keltron receiver. The
3158 reports alarms, supervisories, and troubles.
The steps for connecting the 3158 to the control panel. Refer to the 3158 installation instructions for complete
information.
1. Wire the 3158 to the control panel as shown in the connection list.
2. Wire the 3158 within 20 feet of the control panel. Wiring must be enclosed in conduit.
3. Program control panel Relay 1 for alarm.
4. Program circuit 1 for alarm.
5. Program circuit 2 for supervisory non latching.
4.18.2

City Box Connection Using the 5220 Module

This section describes how to connect the control panel to a local energy municipal fire alarm box or "city box"
as required by NFPA 72 Auxiliary Protected Fire Alarm systems for fire alarm service. The city (master) box is
Figure 4-54 Keltron 3158 Connection to FACP
4-41
LS10144-001SK-E
Not suitable for
remote station
protected premises
service where
separate transmission
circuits are required
for fire supervisory (if
applicable), and
trouble signals.
Intended for
connection to a
polarity reversal
circuit of a remote
station receiving unit
having compatible
ratings.