Programming Options - Honeywell ADEMCO 6152RF Installation And Setup Manual

Table 6 – Programming Options
After editing any programming address, pressing
Enter
Moves to Address
Program
Description
Address
Enter [1] Keypad Address
Enter [2]
Receiver Address
Enter [3] House ID
Only needed if RF keypads
and/or bi-directional units are
used and House ID source is
set for Local.
Enter [4] House ID Source
Enter [5] Wireless Key Editing
Enter [6]
Receiver Enable
Enable the receiver if RF
transmitters or wireless
keypads are programmed into
the control.
Enter [7] Transmitter Module Enable
Enable if using bi-directional
devices.
Enter [8] Wireless Key Auto Enroll
Wireless Key User Code
Wireless Key Loop
Function
Wireless Key On-Board
Relay Assignment
Enter [9] Restore Defaults
Enter [0]
High Security Mode†
Enter [A]
User Code
1
For VISTA-10P/15P/20P/21IP use Keypad Addresses 16-23; For VISTA-50P use Keypad Addresses 00-30.
2
For VISTA-10P/15P/20P/21IP use Receiver Address 00; For VISTA-50P use Receiver Addresses 01-30 and enable the receiver address in the Control
panel.
Note: Not intended for use with VISTA-128/250 Series.
†
When operating the system in High-Security mode, non-encrypted wireless keys will not function.
Upon exiting the Program mode, the 6152RF alternately flashes "Ad," the 2-digit keypad address, and the 2-digit receiver address. If
either of these is incorrect, enter Program Mode again and reset the address(es) (see Tables 5 and 6).
will save the displayed information and return to the Start screen.
Display Choices
1
cA 00-31
2
rA 00-30
hI 00-31
hS 1 = System
0 = Local
d- Enter Existing Device
Number (1-8)
rE 1 = On (Enable)
0 = Off (Disable)
tE 1 = On (Enable)
0 = Off (Disable)
See Programming Local Wireless Keys
for Address 8 programming details
EE 1 = Restores Defaults
Any Other Key = Does
Not Restore Defaults
En 1 = Enable;
0 = Disable
u4 Enter 4-Digit User Code
(0000 – 9999)
- 3 -
Default
Enable keypad address in the
16
Control panel.
00
10 The House ID entered here
MUST match the House ID
programmed in the RF
keypad and the bi-directional
unit.
System uses the House ID
1 (System)
programmed in the control.
Local uses the House ID
programmed in the keypad.
1 (Enable) If enabled, the number of
receivers cannot exceed the
control panel capacity.
Enable Transmitter Module in
1 (Enable)
only one keypad if more than
one 6152RF is used and the
House ID source is 'System'.
0 Disable
This user code will be used to
enable the single button
arming keys. Must be a valid
user code programmed in the
control.
Notes