Cisco UC320W Administration Manual page 76

• Two (2) Attachment Arm Screws
• Auxiliary Interconnect Cable
• Stand
Place the IP phone and Cisco SPA500S face down on a flat surface, with Cisco
STEP 1
SPA500S on the left.
Align the attachment arm over the peg holes on the right side of the phone and the
STEP 2
left side of Cisco SPA500S. Insert the attachment arm pegs into the peg holes.
Using the attachment arm screws, secure the attachment arm to the phone and
STEP 3
Cisco SPA500S.
Locate the AUX IN port on the back of Cisco SPA500S. Connect one end of the
STEP 4
auxiliary cable to this port.
Locate the AUX port on the back of the IP phone. Connect the other end of the
STEP 5
auxiliary cable to this port. Cisco SPA500S is powered by the auxiliary cable with
the IP phone; no additional power source is required.
!
Do not plug a phone line cord into the AUX port. Use
CAUTION
with Cisco SPA500S.
only the auxiliary cable provided
76