Mitsubishi Electric MR-E A Series Instruction Manual page 294

15. MR-E-
Class No. Symbol
60
www.DataSheet4U.com
61 GD2B Ratio of load inertia moment to servo motor inertia moment 2
62
63 VG2B Speed control gain 2 changing ratio
64 VICB
AG SERVO AMPLIFIER COMPATIBLE WITH ANALOG INPUT
LPF Low-pass filter/adaptive vibration suppression control
Used to selection the low-pass filter and adaptive vibration
suppression control. (Refer to Chapter 8.)
0
Low-pass filter selection
0: Valid (Automatic adjustment)
1: Invalid
When you choose "valid",
bandwidth filter is set automatically.
Adaptive vibration suppression control selection
Choosing "valid" or "held" in adaptive vibration
suppression control selection makes the machine
resonance control filter 1 (parameter No. 58) invalid.
0: Invalid
1: Valid
Machine resonance frequency is always detected
and the filter is generated in response to resonance to
suppress machine vibration.
2: Held
The characteristics of the filter generated so far are held,
and detection of machine resonance is stopped.
Adaptive vibration suppression control sensitivity selection
Used to set the sensitivity of machine resonance detection.
0: Normal
1: Large sensitivity
Used to set the ratio of load inertia moment to servo motor inertia
moment when gain changing is valid.
For manufacturer setting
Don't change this value by any means.
Used to set the ratio of changing the speed control gain 2 when gain
changing is valid.
Made valid when auto tuning is invalid.
Speed integral compensation changing ratio
Used to set the ratio of changing the speed integral compensation
when gain changing is valid. Made valid when auto tuning is invalid.
Name and function
VG2 setting 10
2 (1 GD2 setting 0.1)
15 - 49
Initial Setting
Unit
value range
0000
Refer to
Name
and
function
column.
[H ]
z
70 0.1 0
times to
3000
100
100 % 10
to
200
100 % 50
to
1000
Control
mode
S T
S
P S
P S