Adjusting Delivery Of Staple Stack (Lower Delivery) - Canon Finisher-AK1 Service Manual

5
Adjustment > Auxiliary Adjustment > Adjusting Delivery of Staple Stack (lower delivery) > Procedure

Adjusting Delivery of Staple Stack (lower delivery)

Execute this adjustment in the case of paper displacement (the 1st up to the 3rd cover sheet)
in staple stack delivery mode or replacing the finisher controller PCB.
Adjusting method is as follows:
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Auxiliary Adjustment > Adjusting Delivery of Staple Stack (lower delivery) > Procedure
ENTER
F-5-182
2) Pressing switch SW385 [1] activates the LED [2] with "0" blinking. The Adjustment is ready
now.
SW382
SW381
SW383 SW384 SW385
(-) (+)
3) Set 3 sheets of A4-size originals on the ADF. Specify 1 set of A4 size (staple-sort) on the
control panel.
4) Execute copy with the start key on the control panel.
[2]
ENTER
[1]
F-5-183
5-78
5-78