Table of Contents
Advertisement
5
Adjustment > Basic Adjustment > Outline
Basic Adjustment
Outline
CAUTION: Setting the Dip Switch
If setting the Dip Switch, the Delivery Tray setting on the host machine side returns to
the default.
After setting the Dip Switch, it is necessary to execute the Delivery Tray setting on the
host machine side again.
Except for some items, the adjustment and setting can input from the both devices of the host
machine (service mode) and the finisher (Dip switch).
The input value is memorized in the EEPROM of finisher controller. Regardless of the input
device (host machine or finisher), the setting range and unit are same, and the final input
value is effective.
Bit setting of DSW1
Item
in the finisher
controller PCB
Bufferless Mode
ON:1, 3, 8
Adjustment in the Case
ON:1, 3, 6, 7
of Failure in Stacking
Performance of Tray
(upper curl)
Adjustment in the Case
ON:1, 3, 6, 7
of Failure in Stacking
Performance of Tray
(lower curl)
Adjustment in the Case
ON:1, 3, 7
of Failure in Stacking
Performance of Tray
(runon of paper when
using thin paper)
Adjustment in the Case
ON:1, 3, 5
of Canceling Limit for
Tray Stack
Setting of Pressless
ON:1, 3, 4
Mode
5
Adjustment > Basic Adjustment > Outline
Service mode
Range Default
Reference
SORTER> OPTION
0 to 4
0
p. 5-53
>BUFFSW
SORTER>OPTION
0 to 2
0
p. 5-54
>CURLSW
SORTER>OPTION
0 to 2
0
p. 5-56
>CURLSW
SORTER>OPTION
0 to 1
0
p. 5-58
>TRYEJCT
SORTER>OPTION
0 to 1
0
p. 5-60
>TRYOVER
SORTER>OPTION
0 to 3
0
p. 5-120
>SDLPRS
At the occurrence of the following symptoms or at adjustment timing, perform the appropriate
adjustment.
Adjustment Type
Height Adjustment
Jam with this equipment
Side Registration/Skew
Shaky vibration on this equipment (due to large
Adjustment
operating level of the side registration unit) or large
skew
Adjusting Sensor Light
When installing the Finisher or replacing a sensor
Intensity
T-5-1
Symptom, adjustment timing
5-2
Reference
p. 5-3
p. 5-6
p. 5-10
T-5-2
5-2
Advertisement
Table of Contents
