Connecting With The Multi Drawer Document Insertion Unit - Canon Finisher-AK1 Service Manual

7) Check the height between Finisher and the host machine.
CAUTION:
Height difference should be within +/- 2 mm.
Execute "Height Adjustment" if the difference is +/- 2 mm or more.
Host Machine
Finisher
8) Install the Rear Small Cover. (1 Screw)
9) Install the Shunt Cable.
• 2 Screws (RS tightening; M4x10)
x2
7
Installation > Installation Procedure > Connecting with the Multi Drawer Document Insertion Unit
F-7-27
F-7-28
7 Installation > Installation Procedure > Connecting with the Multi Drawer Document Insertion Unit
Connecting with the Multi Drawer Document Insertion
Unit
NOTE:
Be sure the power of the host machine is turned OFF and the power plug is
disconnected from the outlet.
1) Remove 2 Screws from Multi Drawer Document Insertion Unit upper left side.
(The removed screws are not in use anymore.)
x2
7-12
F-7-29
7-12