Punch Skew Tolerance Adjustment Mode - Canon Finisher-AK1 Service Manual

5
Adjustment > Auxiliary Adjustment > Punch skew tolerance adjustment mode > Procedure

Punch skew tolerance adjustment mode

Execute the adjustment in the following cases.
• When displacement of hole position (within 8.5 mm) occurs and paper is skewed on the
way from when it passes through the Delivery Outlet until it is aligned with the Alignment
Plate at the time of delivery.
<Displacement of hole position>
<When paper is skewed on the way from when it passes through the Delivery Outlet until it is
aligned with the Alignment Plate>
[1]
5 Adjustment > Auxiliary Adjustment > Punch skew tolerance adjustment mode > Procedure
F-5-328
F-5-329
NOTE:
By executing this adjustment, hole position accuracy improves. On the other hand, to
prioritize productivity over skew correction, skew correction amount can be adjusted
within the range.
The operation procedure is shown below.
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
■ Procedure
1) Set DIP SW382 [1] on the Switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-330
5-132
5-132