Removing The Lower Stack Delivery Roller Clutch (Cl102); Removing The Escape Feed Clutch (Cl101) - Canon Staple Finisher-AA1 Service Manual

[1]
CAUTION:
Point to Note When Installing the Paddle
• Insert the claw of the paddle [1] into the groove [2].
• Align the paddle end face [3] with the shaft end
face [4].
[2]
[3]
[4]
[1]
[1]
■ Handling after parts replacement
1. Clear the parts counter.
(LV1) COPIER > COUNTER > DRBL-2 > FIN-MPDL
[2]
[1]
[2]
[3]
[1]
[4]
[1]
Removing the Lower Stack
[2]
Delivery Roller Clutch (CL102)
■ Preparation
1. Remove the rear cover.
" Removing the Rear Cover" on page 94
■ Procedure
1. Remove the clutch [1].
• 1 connector [2]
• 1 clip [3]
■ Handling after parts replacement
1. Clear the parts counter.
(LV1) COPIER > COUNTER > DRBL-2 > SW-RL-CL
Removing the Escape Feed
Clutch (CL101)
■ Preparation
1. Remove the rear cover.
" Removing the Rear Cover" on page 94
2. Remove the puncher unit.
NOTE:
Only when the puncher unit is installed, refer the
installation procedure to remove the puncher unit.
■ Procedure
1. Remove the support plate [1].
• 1 screw [2]
114
4. Parts Replacement and Cleaning
1x
[1]
[3]
[2]