4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Stack Unit (Lower) > Procedure
CAUTION:
When putting down the Neat Stack Unit (Upper), be sure to place the unit with the 2
Alignment Plates [1] facing up.
[1]
4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Stack Unit (Lower) > Procedure
Removing the Neat Stack Unit (Lower)
■ Preparation
1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
■ Procedure
CAUTION:
When replacing or installing/removing the component parts of the Neat Stack Unit
(Lower), be sure to perform the following adjustment.
• Adjusting the Alignment Position of the Lower Neat Alignment Plate(Refer to page
5-19)
[1]
1) Lift the Tray A [1] to the upper limit position.
2) Open the Edge Saddle [2] and the 5 Wire Saddles [3], and disconnect the 3 connectors [4].
F-4-134
[2]
x2
x2
[1]
[4]
[3]
[3]
[4]
4-59
x4
F-4-135
4-59