Canon Finisher-AK1 Service Manual page 351

3) If the difference exceeds +/-2 mm range, adjust the height.
NOTE:
Adjust the height with 4 Casters as shown in the figure.
7
Installation > Adjustment > Height Adjustment > Height Adjustment
F-7-98
7 Installation > Adjustment > Height Adjustment > Height Adjustment
■ Height Adjustment
1) Separate the Finisher from the upstream equipment.
• Disconnect the power plug from the outlet.
• Disconnect the power cable of the finisher.
• Disconnect the ARCNET cable.
• Remove the shunt cable.
• Remove the Latch Receivers (Front and Rear)
2) Open the Finisher Front Cover and remove the spanner.
• 1 Screw
Spanner
Screw
7-35
F-7-99
7-35