Connecting With The Host Machine - Canon Finisher-AK1 Service Manual

Connecting with the Host Machine

NOTE:
Be sure the power of the host machine is turned OFF and the power plug is
disconnected from the outlet.
1) On the host machine's Upper Left Side Cover, install the Latch Receiver (Front) and Latch
Receiver (Rear).
• 4 Screws (RS tightening; M4x10)
CAUTION:
Confirm the engraved mark on each latch plate when attaching.
• Latch Receiver (Front) : F
• Latch Receiver (Rear) : R
R
x4
Latch Receiver (Rear)
7
Installation > Installation Procedure > Connecting with the Host Machine
F
Latch Receiver (Front)
F-7-21
7 Installation > Installation Procedure > Connecting with the Host Machine
2) Install the Positioning Pin.
• 2 Screws (RS tightening; M4x10)
x2
7-10
F-7-22
7-10