Canon Finisher-AK1 Service Manual page 333

4) Lower the Latch Plate (Front) and fix it.
• 1 Screw (Use the Screw removed in the step 7) of "Before Installing the Finisher")
5) Close the Finisher Front Cover.
6) Move the Latch Plate (Rear) in the direction of the arrow and insert it to the pin to fix it.
• 1 Screw (Use the Screw removed in the step 9) of "Before Installing the Finisher")
Latch Plate (Rear)
Screw
7
Installation > Installation Procedure > Connecting with the the Professional Puncher Integration Unit
Latch Plate (Front)
Screw
F-7-42
F-7-43
7 Installation > Installation Procedure > Connecting with the the Professional Puncher Integration Unit
7) Check the height between Finisher and the Professional Puncher Integration Unit.
CAUTION:
Height difference should be within +/- 2 mm.
Execute "Height Adjustment" if the difference is +/- 2 mm or more.
Finisher
8) Install the Rear Small Cover. (1 Screw)
9) Install the Shunt Cable.
• 2 Screws (RS tightening; M4x10)
x2
7-17
Professional Puncher
Integration Unit
F-7-44
F-7-45
7-17