Side Registration/Skew Adjustment - Canon Finisher-AK1 Service Manual

9) Rotate the Adjusting Bolt with the spaner. Adjust the height (that was measured in step 6))
to be within 86.3 +/- 0.3 mm.
• To increase the height : rotate in the direction of [A].
• To lower the height : rotate in the direction of [B].
(Height increment per rotation : approx.1.75 mm)
[A]
10) Tighten the Fixing Nut in the direction of [B].
[B]
11) Adjust the other 3 casters as well (by repeating the steps above).
12) Reconnect the Finisher with the upstream equipment and check the height.
Install the removed parts such as covers if the height difference is within +/- 2mm.
If not, repeat the steps above to readjust the height.
7
Installation > Adjustment > Side Registration/Skew Adjustment > Checking Adjustment Value
Adjusting Bolt
[B]
F-7-107
Fixing Nut
F-7-108
7 Installation > Adjustment > Side Registration/Skew Adjustment > Checking Adjustment Value

Side Registration/Skew Adjustment

CAUTION:
Only when the Puncher Unit is installed to the Finisher, perform this item.
■ Checking Adjustment Value
● Preparations
1) Turn ON the power of the finisher then the host machine.
2) Open the Finisher Front Cover and put the Door Switch Tool into the door switch.
7-38
F-7-109
7-38