Canon Finisher-AK1 Service Manual page 357

2) Lift the Upper Cover in the arrow direction to remove the Inner Cover (Upper).
• 4 Screws
Inner Cover (Upper)
x4
3) Remove the Latch Base Cover.
• 3 Screws
x3
7
Installation > Adjustment > Side Registration/Skew Adjustment > Skew Adjustment
Upper Cover
F-7-116
F-7-117
7 Installation > Adjustment > Side Registration/Skew Adjustment > Skew Adjustment
4) Loosen the 2 screws on the Latch Plate (Front).
5) If the value obtained at "Checking Adjustment Value" is "+ (positive)", move it in [A]
direction and tighten the 2 screws.
If the value obtained at "Checking Adjustment Value" is "- (negative)", move it in [B]
direction and tighten the 2 screws.
CAUTION:
Perform adjustment so that the total of the shifting amount (scale) of the Latch Plate
(Front/Rear) is within -2 to +2 mm.
Screw
7-41
[A] [B]
F-7-118
7-41