Removing The Puncher Unit - Canon Finisher-AK1 Service Manual

4
Parts Replacing and Cleaning > Feed Assembly > Removing the Puncher Unit > Procedure

Removing the Puncher Unit

■ Preparation
1) Open the Front Cover.
2) Separate the finisher from the host machine.(Refer to page 4-18)
3) Remove the Rear Cover.(Refer to page 4-20)
4) Remove the Inner Cover (Upper).(Refer to page 4-22)
■ Procedure
1) Remove the Punch Dust Box Unit [1].
[1]
4 Parts Replacing and Cleaning > Feed Assembly > Removing the Puncher Unit > Procedure
F-4-94
2) Disconnect the 2 connectors [2] connected to the Finisher Controller [1].
[1]
x2
[2]
[2]
3) Free the harness [1] of the Puncher Unit.
• 1 Edge Saddle [2]
• 1 Harness Guide [3]
• 1 Connector [4]
[4]
4-46
F-4-95
[3]
[1]
[2]
F-4-96
4-46