8) Check the height between Finisher and the Multi Drawer Document Insertion Unit.
CAUTION:
Height difference should be within +/- 2 mm.
Execute "Height Adjustment" if the difference is +/- 2 mm or more.
Finisher
9) Install the Rear Small Cover. (1 Screw)
10)
Install the Shunt Cable.
• 2 Screws (RS tightening; M4x10)
x2
7
Installation > Installation Procedure > Connecting with the the Professional Puncher Integration Unit
Multi Drawer Document
Insertion Unit
F-7-36
F-7-37
7
Installation > Installation Procedure > Connecting with the the Professional Puncher Integration Unit
Connecting with the the Professional Puncher
Integration Unit
NOTE:
Be sure the power of the host machine is turned OFF and the power plug is
disconnected from the outlet.
1) Install the Latch Receiver (Front) and Latch Receiver (Rear) in the Professional Puncher
Integration Unit Upper Left Stay.
• 4 Screws (RS tightening; M4x10)
CAUTION:
Confirm the engraved mark on each latch plate when attaching.
• Latch Receiver (Front) : F
• Latch Receiver (Rear) : R
R
x4
Latch Receiver (Rear)
7-15
F
Latch Receiver (Front)
F-7-38
7-15