Adjusting Assist Stopper Position - Canon Finisher-AK1 Service Manual

5
Adjustment > Auxiliary Adjustment > Adjusting Assist Stopper Position > Procedure

Adjusting Assist Stopper Position

Execute this adjustment in the case of variation in the top sheet of the stapled delivery stack.
Adjustment method is as follows:
■ Preparations
1) Remove the Process Tray Unit. (Refer to page 4-62)
■ Procedure
1) Set A4 or LTR size paper [1] on the intermediate process tray in the arrow direction, and
then measure displacement amount [A] between the paper edge stopper [2] and the assist
stopper [3].
When the measurement value (+A or -A) is out of the standard value (within 0 + 0.5 mm in
+A direction), perform the following steps to make the value within the range.
+A
[1] [2] [3] [2]
5 Adjustment > Auxiliary Adjustment > Adjusting Assist Stopper Position > Procedure
[1]
-A
[1] [2] [3] [2]
F-5-226
29) Remove the 2 screws [2], and remove the Assist Stopper [1].
x2
[2]
310) Loosen the screw [1] of the assist stopper to adjust the displacement amount of the
stopper [2] to be within the specified value [3].
[2]
[1]
CAUTION:
If the reference value [3] measured in the previous step is -A, move the stopper [2] in
the direction of the white arrow. If the reference value [3] measured in the previous step
is +A, move the stopper [2] in the direction of the black arrow.
411) Install the Assist Stopper removed in step 4.
• 2 Screws
512) Install the removed parts in reverse order.
5-97
[1]
F-5-227
[3]
F-5-228
5-97