Table of Contents
Advertisement
HUAWEI USG6000E Series
Hardware Guide
To prevent USG overheating, replace the fan module within 1 minute.
Tools
ESD wrist strap
Procedure
Step 1 Wear an ESD wrist strap.
Step 2 Remove the faulty fan module.
Press upwards the fan module latch, hold the handle of the fan module, and pull
out part of the fan module. After the fan stops rotating, slowly pull out the fan
module from the chassis.
Step 3 Install a new fan module.
Hold the handler of the fan module with one hand and the bottom of the fan
module with the other hand, insert the fan module along the guide rail of the fan
slot until the back of the fan module gets in good contact with the chassis
backplane. After the latch on the power module is tightened, pull the fan module
gently to check whether it can be removed.
Figure 6-4 Replacing the fan module
Step 4 Check the FAN STATUS indicator on the panel. If the indicator is blinking green
every two seconds (0.5 Hz), the new fan module works properly.
----End
Issue 08 (2022-04-20)
NO TICE
Copyright © Huawei Technologies Co., Ltd.
6 Maintaining the Hardware
586
Hide quick links:
Advertisement
Table of Contents
