Huawei USG6000E Series Hardware Manual page 237

HUAWEI USG6000E Series
Hardware Guide
Item
Input voltage range [V]
Maximum input current [A]
Maximum output power [W]
Types of fans
Number of fan modules
Heat dissipation mode
Airflow direction
Maximum number of 10GE ports
Maximum number of GE ports
Maximum number of electrical ports
Redundant power supply
Redundant fans
Long-term operating temperature
[°C(°F)]
Storage temperature [°C(°F)]
Long-term operating relative humidity
[RH]
Storage relative humidity [RH]
Long-term operating altitude [m(ft.)]
Storage altitude [m(ft.)]
Issue 08 (2022-04-20)
NO TE
● The width does not include the size of mounting ears.
● The height is 1U (1U = 1.75 inches, or about 44.45 mm), which is a height unit defined
in International Electrotechnical Commission (IEC) 60297 standards.
● Temperature and humidity are measured 1.5 m above the floor and 0.4 m in front of the
rack when no protection plate exists before or after the rack.
● The operating temperature change rate of a device with HDDs must be less than or
equal to 20°C/hour.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Overview
Specification
90 V to 290 V, 47 Hz to 63 Hz
9 A
600 W
Pluggable
3
The fan module locates at the air
exhaust of the system.
Air inlet from front and air outlet from
rear
4
8
12
Two power modules are supported for
1+1 power redundancy.
2+1
Without hard disk driver: 0°C to 45°C
With hard disk driver: 5°C to 40°C
-40°C to 70°C
5% RH to 95% RH, non-condensing
5% RH to 95% RH, non-condensing
Without hard disk driver: 0 m to 5000
m
With hard disk driver: 0 m to 3000 m
0 m to 5000 m
230