Huawei USG6000E Series Hardware Manual page 529

HUAWEI USG6000E Series
Hardware Guide
Figure 5-12 Connecting a PGND cable
The OT terminal may rotate and result in device damage. Make sure that it is
independent of the adjacent metal mechanical part or other terminals.
----End
Follow-up Procedure
Verify the following after the cabling is complete:
●
●
5.3.3 Installing a Micro SD Card
This section describes how to install a micro SD card for the first time to avoid
damages.
Precautions
●
Issue 08 (2022-04-20)
NO TICE
The PGND cable is securely connected to the ground terminal.
The electrical resistance between the ground terminal and ground point is less
than 0.1 ohm on a multimeter.
Micro SD cards are optional and are not delivered with the device. If required,
purchase the micro SD card (part number: 06010308) from Huawei. The micro
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Installation
522